Product Details
Description
Performance Ceramic ('Z' Compound Code)
Performance Ceramic is engineered to reduce brake NVH (Noise, Vibration and Harshness) creating a quieter performing brake pad. Furthermore, the ceramic brake pad formula has a linear friction profile that allows your ABS brake system to work more effectively. With Performance Ceramic you can expect reduced brake pad wear, lower dust output levels and a rotor-friendly brake pad.
Notes: w/o Wear Sensor Notch
Thickness: 0.572mm
Product Features
- Enhanced braking performance.
- Longer-lasting rotors.
- Extended pad lifespan.
- Minimal brake dust.
- Quieter operation.
- Consistent friction output.
OE Numbers
- 8E0698151H
- 8E0698151Q
- 3D0698151A
installation
Installation Procedure
- Install brake pads properly. Be sure pads are securely positioned in the caliper.
- Flush system with fresh brake fluid.
- Check all hydraulic parts for excess wear and tear.
- Check disc for proper thickness, parallelism, and lateral runout.
- Check disc for scoring or grooves over .012”depth. If either applies, resurfacing is required.
- If discs do not need resurfacing, then contamination from the previous brake pads must be removed. Sand discs with 130-grit sandpaper using moderate pressure. Use soap and water to clean disc surface after sanding and machining. Discs should be free and clear of oil, grease, and brake fluid.
- Inspect calipers for freedom of movement. Lubricate where necessary.
Bed-In/Burnishing Instructions
- After installing new brake pads, make 6-to-10 stops from approximately 30-35 MPH applying moderate pressure.
- Make an additional 2-to-3 hard stops from approximately 40-45 MPH.
- DO NOT DRAG BRAKES!
- Allow at least 15 minutes for the brake system to cool down.
- After step 4 is completed, your new Hawk Performance brake pads are ready for use.
warranty
Lifetime Warranty
Customer Pictures
No images yet
Customer Reviews
No reviews have been written for this product.
Write a Review