Product Details
Description
HPS (‘F’ Compound Code)
When it comes to performance braking, there is no competition. This unique Ferro-Carbon compound combines the safety and quality of Aerospace design partnered with the braking technology of motorsports. Much improved braking over OE and standard replacement brake pads. Recommended for import & domestic automobiles.
Specs
- Position: Rear
- w/0.642 Thickness
Note: For Rear Brakes W/ "Bosch" cast into the caliper body
Product Features
- Increased Stopping Power
- High Friction/Torque Hot or Cold
- Gentle on Rotors
- Extended Pad Life
- Low Dust
- Virtually Noise-Free
OE Numbers
- 8E0698451K
- 8E0698451L
installation
Installation Procedure
- Install brake pads properly. Be sure pads are securely positioned in the caliper.
- Flush system with fresh brake fluid.
- Check all hydraulic parts for excess wear and tear.
- Check disc for proper thickness, parallelism, and lateral runout.
- Check disc for scoring or grooves over .012”depth. If either applies, resurfacing is required.
- If discs do not need resurfacing, then contamination from the previous brake pads must be removed. Sand discs with 130-grit sandpaper using moderate pressure. Use soap and water to clean disc surface after sanding and machining. Discs should be free and clear of oil, grease, and brake fluid.
- Inspect calipers for freedom of movement. Lubricate where necessary.
Bed-In/Burnishing Instructions
- After installing new brake pads, make 6-to-10 stops from approximately 30-35 MPH applying moderate pressure.
- Make an additional 2-to-3 hard stops from approximately 40-45 MPH.
- DO NOT DRAG BRAKES!
- Allow at least 15 minutes for the brake system to cool down.
- After step 4 is completed, your new Hawk Performance brake pads are ready for use.
warranty
Lifetime Warranty
Customer Pictures
No images yet
Customer Reviews
No reviews have been written for this product.
Write a Review