Introducing the all new RSe102 lightweight wheels, a modern rendition of our classic and original full forged RS10

The RSe102 shares the same 10-spoke count but the full-face profile and bevel lip modernize its design. 

Each RSe102 is spec-ed specifically for the assigned vehicle, which translates to complete direct bolt-on fitment utilizing factory lug bolts, center caps, as well as tire pressure monitoring sensors (if applicable) – No spacers or adapters!

The same as NEUSPEED's other wheels, the RSe102 is manufactured utilizing Flow Forming process. It is a hybrid process between low-pressure casting and forging technology. This process produces ultra lightweight wheel similar to full forged wheels but a fraction of the cost. 

Weighing just a mere 20 lbs, The RSe102 wheels will enhance your driving experience cosmetically as well as the performance by reducing the rotational mass or unsprung weight.

Specs

• Size: 19x8.5
• Offset (E.T.): +45mm
• PCD (Bolt Pattern): 5-112
• Center Bore: 57.1mm
• Weight: 20 lbs.

Recommended Tire Size:

*These sizes are only to be used as a guide*

*For Vehicles that are stock height or slightly lowered.*

*Extremely low vehicles may need a tire width that is smaller*

Wheel Bolts:

Neuspeed Wheels use the OEM wheel bolt size and design. You can reuse your OEM wheel bolts with these wheels! 

• OEM Wheel Bolt Specs:
• Thread Type: 14 X 1.5"
• Thread Length: 28mm Shank
• Seat Type: Ball 
• Head: 17mm Hex

Replacement OEM Wheel bolts: Otis Inc 27mm Ball Seat Wheel Bolts

Notes:

• RSe wheels are OEM TPMS (Tire Pressure Monitoring System) compatible.
• Every RSe wheel comes with 'RS' center cap. However, one can choose to utilize early style OEM Audi or VW center cap as well as mounting lug bolts, which are not included with the wheel.
• Audi cap part #: 4B0 601 170
• VW cap part #: 3B7 601 171
• Compatible with Brembo, Stoptech and many other BBKs without wheel spacers/adapters.
• Audi RS3 (8Y) Fitment Note: Front fenders are much wider than the rears. For a square setup, +20mm front spacer is recommended to achieve flush fitment matching the rear.