The NEUSPEED RSe05 is a lightweight alloy wheel with unmatched quality, perfectly spec-ed for your car. With its design adapted from the European touring challenge cars, the RSe05 will enhance your driving experience and performance by reducing the rotational mass or unsprung weight.

Each RSe05 is spec-ed specifically for the assigned vehicle, which translates to complete direct bolt-on fitment utilizing factory lug bolts, center caps, and tire pressure monitoring sensors (if applicable) – No spacers, No hub rings!!

Weighing just a mere 21.5 lbs, The RSe05 wheels will enhance your driving experience and performance by reducing the rotational mass or unsprung weight.

Specs

• Size: 19x8.5
• Offset (E.T.): +45mm
• PCD (Bolt Pattern): 5-112
• Center Bore: 57.1mm
• Weight: 21.5 lbs.

Recommended Tire Size:

*These sizes are only to be used as a guide*

*For Vehicles that are stock height or slightly lowered.*

*Extremely low vehicles may need a tire width that is smaller*

Wheel Bolts:

Neuspeed Wheels use the OEM wheel bolt size and design. You can reuse your OEM wheel bolts with these wheels! 

• OEM Wheel Bolt Specs:
• Thread Type: 14 X 1.5"
• Thread Length: 28mm Shank
• Seat Type: Ball 
• Head: 17mm Hex

Replacement OEM Wheel bolts: Otis Inc 27mm Ball Seat Wheel Bolts

Notes:

• RSe wheels are OEM TPMS (Tire Pressure Monitoring System) compatible.
• Every RSe wheel comes with 'RS' center cap. However, one can choose to utilize an early style OEM Audi or VW center cap and mounting lug bolts, which are not included with the wheel.
• Audi cap part #: 4B0 601 170
• VW cap part #: 3B7 601 171
• Compatible with Brembo, Stoptech, and many other BBKs without wheel spacers/adapters.
• Audi RS3 (8Y) Fitment Note: Front fenders are much wider than the rears. For a square setup, +20mm front spacer is recommended to achieve flush fitment matching the rear.