Introducing the all-new NEUSPEED FlowForm RSe122 in 18-inch. This light-weight wheel features a modern race-inspired mesh design paired with the classic look of a lipped race wheel. The visually open design allows your big brake setup to pop behind the modern cut split Y-spoke face, while also open enough to help cool the brakes under hard driving. On the edge of the wheel is a retro race inspired lip optimizing rigidity and strength, all while adding a little flair to your Audi or Volkswagen.

As with all NEUSPEED FlowForm wheels, these are designed and engineered specifically for Audi and Volkswagen vehicles. Thus allowing for complete, direct bolt-on fitment utilizing factory lug bolts, center caps, and tire pressure monitor sensors (if applicable).

Specs

• Size: 18x8.5
• Offset (E.T.): +45mm
• PCD (Bolt Pattern): 5-112
• Center Bore: 57.1mm
• Weight: 21 lbs.

2022+ 8Y RS3 Fitment Notes

• Fits vehicles with steel brakes only.
• Tight clearance -- Installer must confirm barrel to balancing weight clearance.
• +5mm minimum spacer is required to clear front brakes.
• Front fenders are much wider than the rears. For square setup, +20mm front spacer is recommended to achieve flush fitment matching the rear.

Recommended Tire Size:

*These sizes are only to be used as a guide*

*For Vehicles that are stock height or slightly lowered.*

*Extremely low vehicles may need a tire width that is smaller*

Wheel Bolts:

Neuspeed Wheels use the OEM wheel bolt size and design. You can reuse your OEM wheel bolts with these wheels! 

• OEM Wheel Bolt Specs:
• Thread Type: 14 X 1.5"
• Thread Length: 28mm Shank
• Seat Type: Ball 
• Head: 17mm Hex

Replacement OEM Wheel bolts: Otis Inc 27mm Ball Seat Wheel Bolts

Notes

• RSe wheels are OEM TPMS (Tire Pressure Monitoring System) compatible.
• Every RSe wheel comes with 'RS' center cap. However, one can choose to utilize OEM Audi or VW center cap as well as mounting lug bolts, which are not included with the wheel.
• Audi cap part #: 4B0 601 170 A
• VW cap part #: 3B7 601 171
• RSe wheels utilize OEM lug bolts with R13 ball seat (Audi & VW specific)
• Compatible with Brembo, Stoptech and many other BBKs without wheel spacers/adapters.